Jeep started ripping the carpet floors all to shreds so I had to do something. I had left over Plexiglas from a window job so I used that to put down over the wire mesh of the cage floors after I took the carpet out. I got one full floor and one full floor that was made into a bi-level and this seemed to work out fine. But Jeep had other ideas and began ripping out the carpet on the next floor down and I expect the top floor to get it too. So I have another sheet of Plexiglas all marked out for cutting to include the slot for the ramp enterance/exit. Have only to cut that to size and will get the last two full floors to cover. This will be a trial where I have to remove the 'J' clips on two places to slide the new Plexiglas in. This is a major job but will just have to be done. I have no choice. I found some colored sheets to put under all of the new floors so Jeep won't get the feeling he is on other than solid floor where the see thru part seems to throw him off a tiny bit. Over all he does just fine. Jeep is a typical ferret that does not miss a darn thing different in any room. I had some stiff on a chair out on the porch where Jeep runs around every day and for sure he got into every bit of that pushing that all onto the floor. I had coils of extension cord, electric drills, drill keys, bits, spare chain saw chains and all kinds of things knocked to the floor and strewn around. Jeep just had a bell out there. All that made me angry but as I cleaned it all up I just had to laugh at all the catastrophe he caused just being a ferret. At least he is healthy in mind and spirit. Aarrow-Ranch Aviation J. Gordon Bengtson CEO CI-ASMEL *** Virginia is for Power Out Lovers. *** [Posted in FML 7539]